Sea & Sea YS-50 Specifikace

YS-01UNDERWATER STROBE03112

E-9Identification of PartsReflectorFiber-optic cable socket (for additional strobe (P.J-16))Fiber-optic cable socket(Slave sensor (P.J-15))Fiber-optic

E-10OFFTTLMINFULLIdentification of PartsOFFOperationMode SwitchTurns the power off. Set the mode switch to [OFF] when you are not using the strobe.Set

E-11TTLMINFULLPushIdentification of PartsTarget light switchCAUTIONThe target light turns on when you push the target light switch. The target light t

E-12Identification of PartsReady / TTL lampFixing BoltCAUTIONReadyTTLIlluminates in red when the strobe is ready to fire.Illuminates in green for appr

E-131234Insert four batteries aligned to the + and - marks5AA alkaline battery, AA Ni-MH battery, AA oxyride batteryThis model can be powered by the f

E-146Align the round mark and ① on the battery cap with the OPEN ● position, insert the battery cap into the strobe7Turn ① clockwise to the LOCK posit

E-15Connecting the StrobeCAUTION13Some housing are not compatible with fiber-optic cable.When you use this strobe, connect the strobe to the camera (

E-16Connecting the StrobeCAUTIONWhen shooting, set the built-in flash of the camera to the forced-flash mode. The strobe will not fire unless the bui

E-171Manual photographySettings chartTaking PhotographsWhen shooting, set the built-in flash of the camera to the forced-flash mode. The strobe will n

E-18Taking Photographs12To check the mode switchYou can check whether the settings of the mode switch are correct, by shooting the strobe with a digit

E-19Taking Photographs12DS-TTL photographyThe DS-TTL system on this strobe is a slave TTL system with flash dimming functionality. This system is usef

E-20Taking PhotographsUsing the DiffuserUse of the diffuser is highly recommended for shooting short camera-to-subject distances.Attaching the diffuse

E-21Taking PhotographsCAUTIONDo not try to forcibly remove the diffuser with the tab on only one side as doing so may cause breakage.Pinch in and pul

E-22CAUTIONNever use chemicals, cosmetics, any petroleum solvents such as paint thinner, or neutral detergent on the product. They may deform and dam

E-23Controls and functionsMode switch (OFF / / / TTL)Light level control dial (10 increments)Target light switch (ON/OFF)IndicatorGuide number2

Memo

E-2Contents Safety Precautions ...Safety Precautions for Use of Battery ...Acce

E-3For safe handling of the product, please read the following precautions carefully before use. Situations that involve a high risk of severe injury

E-4Safety PrecautionsCAUTIONDo not fire the strobe or illuminate the light towards a driver of a vehicle to avoid causing accidents.Do not operate t

E-5Safety PrecautionsUsing the strobe close to your subject's eyes could cause temporary visual impairment. Particular care should be observed i

E-6Safety Precautions for Use of BatterySafety PrecautionsCarefully observe the O-ring maintenance manual for the handling of O-rings befor use.SEA&

E-7Never use batteries should you notice any changes such as leakage, discoloration or deformation. When you notice the situation as abnormal, discon

E-8AccessoriesBefore using this model, check to make sure that all accessories are present.O-ring Maintenance ManualYS-01 Instruction Manual (this m